I’ve been trying to perfect the process of making these things that I call “Möbius Rollers”.

Issue #1—Painting:

On the top one I used multiple coats of filler primer, sanded it with 100 then 220 grit sandpaper, painted it blue, taped it, painted it green and removed the tape. The paint job came out looking great.

The second one, I used wood filler on the rough areas, which saved me a couple of coats of filler primer. Painted it green, then taped it. But, the tape strips were too small, and didn’t stick well in some areas, so some of the blue paint got under.

Issue #2—Cutting:

There is a channel with ball bearings that ride around inside. In order to get this to print, I have to make the channel just below the surface. Then, I just cut the top of the channel open, so you can see the balls roll around inside.

On the top one I tried different bits on my rotary tool, and when I tried the router bit, I thought it was working at first, but then it skipped all over, and tore the whole thing up.

The second one I tried a grinding wheel bit on a slow speed, and I got a cleaner cut, but it took a long time. Then, after it was open, I tried sanding the channel so the balls would roll smoothly, but I discovered that the channel is pinched in one area, and even a lot of sanding would not open it up. And, even still, I did not like the way the cut came out.

Issue #3—Model:

On my old printer the channels came out wide enough, I don’t know if it’s the slicer, or the printer, but I need to either figure out different print settings, or maybe modify the the model to make the channels bigger. Also, I want to find a way to make the plastic thin enough along the outside of the channel, so that I can pull it open like a zipper.