I found this Golden Rectangle Icosahedron while reading about Icosahedrons on Wikipedia: Regular Icosahedron and wanted to make a 3D print of it. I realized that I could print it with a minimum of supports if I printed it standing on three corners.
Constructing the figure is super easy by making a golden rectangle, duplicating and rotating it two times. The problem that I encountered next was getting three corners resting on the XY plane. You’d think there’d be an easy to use tool or two, or maybe a plug-in, to do this in Blender, but haha–no. After a bunch of googling and wasting time trying to figure out how to do this with Blender tools, I landed on the idea of using duh-duh-duh MATH!
The process is simple, and can be generalized to any object. It requires only simple and familiar Blender tools: moving the origin of an object, translating the object, and rotating the object.
The basic steps are:
- Move the origin of the object to one of the vertices
- Move the object to 0,0,0
- Get the coordinates of the next vertex and find the angle to rotate around the Z axis align it on one of the major axes
- Get the coordinates of the vertex again and calculate the angle to rotate to the XY plane
- Get the coordinates of the last vertex and find the angle to rotate around the axis in step three to the XY plane
I had a lot of trouble getting this to print on my new Prusa I3 MK3. Here’s some troubles I ran into, and how I resolved them:
- After a week of printing fine, I started to notice that first layers were sometimes failing. The solution was to preheat the bed for just a couple of minutes before starting the print.
- I never really had the Z-axis set correctly because the Prusa’s built-in first layer calibration routine is not good, and makes you guess too much. I used the instructions in this thread: life adjust Z – my way (sic), and everything was so much clearer and easier.
Once I had the printer dialed in, I had to experiment a lot with Slic3r settings. I think the most important three settings in getting this to work were enforcing support for the first 40 layers, setting the XY separation to 5%, and setting the infill speed to 375 mm/s².
Model on Thingiverse: https://www.thingiverse.com/thing:2822976
As far as the video itself goes: The Blender session was complete garbage, and I discovered that it’s really hard to edit that type of video. Also, voice overs are hard. Also, the painting was long and unnecessary (and badly done to boot!).